ZX200.2
ZX200.2
TS10L7
TS10L7
Fuses
Fuses
COMPVR // 12 inch
COMPVR // 12 inch
Subwoofers arrow COMP VX arrow COMPVX // 15 inch



COMPVX // 15 inch

Kicker New Zealand

Download Manuals Here

Product Registration

Dealers Near You



 

Model CVX15
 
Size (IN.,CM) 15, 38
Impedance (OHMS) 2 or 4 DVC
Max Rec Amplifier Power (WATTS PEAK/RMS)* 2000/1000
Sensitivity (dB 1w/1m) 92.3
Frequency Response (Hz) 18-500
Mounting Depth (IN.,CM) 8-1/4, 20.9
Mounting Diameter (IN.,CM) 13-7/8, 35.2
Min Rec Sealed Box Volume (CU. FT., Liters) 1.8, 51.0
Max Rec Sealed Box Volume (CU. FT., Liters) 5.2, 147.0
Min Rec Vented Box Volume (CU. Ft., Liters)** 3.0, 85.0
Max Rec Vented Box Volume (CU. Ft., Liters)** 5.0, 142.0

*Assumes typical music program with minimal amplifier clipping; varies with enclosure size. See your KICKER dealer for details.

**Port Volume Excluded.

Due to continual developement, product, and specifications are subject to change without notice. Stillwater Designs and it's agents are not responsible for typographical errors.

 

  • Heavy-duty L7 motor assembly
  • Lighter, round SoloKon
  • Cast aluminum basket
  • T cut top plate
  • Flared aluminum coil former

     

The Hype

CompVX™ Subwoofer Provides High-End Bass in the Round
The facts are there – square woofers have more cone area, move more air, and therefore are louder than round woofers of the same size. But face it; some custom installs don’t lend themselves to the four-sided superiority.

Now, KICKER has allocated all the power and performance of its patented square-woofer technology in the round! Presenting the CompVX Subwoofer, the most intense round woofer on the planet and ready to plug into any high-end install.

It’s the most technologically advanced subwoofer available, with exclusive KICKER design and performance features in a round woofer. Available in the 10-inch CVX10, the 12-inch CVX12, and the 15-inch CVX15, the CompVX Series continues the remarkable legacy of outstanding bass from the KICKER labs.

CompVX utilizes the complete KICKER recipe for bass. Vacuum-molded SoloKon™, poly-cotton semi-progressive spider, dual high-temp voice coils, jacketed braided tinsel leads, highly-efficient UniPlate™ pole piece/back plate, and the heat-reducing T-cut top plate – it all comes together to form a super-reliable motor structure found only in a KICKER subwoofer.

The basket is cast aluminum with spring-loaded terminals that can accept up to 10-gauge wire. A protective front gasket further strengthens the ribbed Santoprene® surround, and the rear foam gasket makes for an airtight seal in the installation.

The CompVX Series is available in 2-Ohm or 4-Ohm DVC and thoroughly pounds in a sealed or vented box application.







Design and hosted by BigNoise WebDesign